Can't set One Wire device function to beer temp

I decided to redo my fermentation chamber this weekend to add a new chamber heater and tidy up the wiring. When I went to start up the pi again, my device list was all out of whack. So, I decided to reinstall the hex file on the Arduino with new settings. I can see both of my temperature sensors and their readings, but when I go to select beer temp for the function and apply the new settings, when I refresh the devices it just reverts to whatever the previous setting was. I am able to select chamber temp or room temp for my sensors, just can’t select beer temp. Any ideas why this is? I’ve attached a pic of my device list below.

Never mind, got it! Forgot to assign the device to a beer.

Thank you. This solved my problem I have been fighting for the past hour