Quick start Mashing

Troubleshooting
1

Hi,
I am running the quickstart Wizzard for my HERMS. I get the Constant HLT element to heat up and the Constant BK element, but when I try to get the Constant MT going the heating element will not start.

Only way to start heating element when using Constant MT is clicking on enable in the block that I have snipped a pic of.
Probably there is a easyer way ?

image
image645×803 25.8 KB

And yes, I get a little confused in all these blocks :smiley:

2

Is your setpoint driver enabled? The setpoint driver gives the HLT setpoint an offset compared to the the mash setpoint, based on the error in the mash temperature (compared to the mash setpoint).