I simplefied my HERMS setup from a fully automated system to a hose swap system. This simply saves me a lot of time, and with 2 kids around I don’t have much of that
All fittings are stainless steel 316, 1/2 inch BSP thread. All stuff is bought from the brewpi store except for the electric valves, they work perfectly with the valve control board.
12x elbow M-F
5x hand ball valve F-F
16x Hose barb M
38x nipple M-M
6x Tee M-F
5x cross F-F-F-F
6x 3 piece coupler F-F
1x Camlock cap
15x Camlock 1/2 male
19x Camlock barb type c
9x valve control board
18x Electric ball valve. I made a connector in the cable so the valve can be disconnected from the control board.
1x Lauterhexe 1 meter
7x junction box for valve control board
Where are you based, would certainly be interested in getting some spares, as they are no longer available through the store.
I live in the Netherlands.
How much do you want for:
6 sets camlocks (male+female)
2 sets electric ball valves (valve, board and enclosure)
And would it be okay to ship it to Denmark?
I’ll just go ahead and be painfully explicit:
DO NOT POST PHYSICAL / E-MAIL ADDRESSES HERE
If you’re not a charity for Nigerian princes, I strongly recommend communicating e-mail addresses or shipping info by private message.
I sent you a personal message.